Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Before
After
Before
After
Before
AfterMr-Glass Roof Replacement & Installation in Fort Lauderdale: What to Know First
We handle independent Mr-Glass roof replacement and installation in Fort Lauderdale for homeowners who want the job set square and sealed against salt air the first time. Most Mr-Glass roof units we replace are turned around in one to three days once we have the panel or frame on hand, and you’ll get a written line-item price before we touch anything. This page is for Fort Lauderdale homeowners who own Mr-Glass roof glazing, skylights, or overhead glass systems and want a straight answer on cost, parts, and whether the unit is worth saving.
If the roof glass is already leaking or the frame is pulling loose, call (754) 310-3589. A live person answers, day or night.
How Mr-Glass Products Fail - and How We Fix Them
Mr-Glass roof systems in Fort Lauderdale take a beating from UV, salt, and storm cycles. Here’s what we actually see on job sites, not what the catalog says might happen someday:
- Weeping seals on older Mr-Glass roof panels. The original butyl and silicone seals on early Mr-Glass overhead units harden after eight to twelve years in Florida sun, then shrink. Water doesn’t pour in, it wicks along the frame channel and shows up as a ceiling stain three feet from the actual breach. We pull the panel, clean the reglet, and reset with a marine-rated sealant bed before reinstalling.
- Frame corrosion at the fastener points. Mr-Glass roof frames from the 1990s and early 2000s used uncoated steel fasteners in several series, and we’ve replaced more than a few where the screw heads had rusted to powder while the aluminum around them looked fine. We swap in stainless hardware and inspect every anchor point before the panel goes back down.
- Stress cracks from thermal movement. Fort Lauderdale’s afternoon heat expands roof glass more than most designs account for, and Mr-Glass units with rigid perimeter stops can develop hairline cracks starting at the corner. If the crack hasn’t reached the structural interlayer, we can sometimes salvage the panel with a polished edge treatment. If it has, replacement is the honest call, and we’ll tell you which one applies before quoting anything.
- Failed glazing tape on curbed Mr-Glass skylight installations. The factory tape loses adhesion over time, and once it lets go the panel sits metal-on-metal. You’ll hear it tick when the sun hits it. We pull the unit, remove the degraded tape, re-level the curb, and bed the replacement on fresh material rather than stacking new tape over old.
- Obsolete hardware on discontinued Mr-Glass lines. Mr-Glass changed hinge and latch vendors at least twice in the years we’ve been working on their roof systems, and parts for the older generation are often gone from the manufacturer’s inventory. We keep a shop stock of common Mr-Glass hardware and can usually machine or source a functional match that preserves the factory warranty where one is still live.
Our Mr-Glass Roof Replacement & Installation Process
Here’s how a Mr-Glass roof replacement runs when you call TruePane Windows & Doors:
- 1
You call, a person answers. We talk through what you’re seeing: where the water shows up, when the glass makes noise, how old the unit is. That tells us whether we’re scheduling a repair visit or a full replacement.
- 2
We measure the opening, not the old glass. Roof frames shift over two decades, and the last installer may have trimmed the panel to fit a warped curb. We measure the actual opening twice, because a roof panel doesn’t forgive a quarter-inch miss the way a window might.
- 3
We quote you in writing, side by side. If replacement is the right call, you’ll see OEM Mr-Glass pricing next to a quality aftermarket equivalent, with the differences spelled out. You decide what goes in; we register whatever warranty applies before we leave.
- 4
We swap the panel or rebuild the frame. The old unit comes out, the structure gets inspected, and the new glass goes in with a sealant and fastener spec matched to Fort Lauderdale’s wind and salt exposure.
- 5
We water-test, then we clean up. After the install we run water across every seam and watch the interior. If it holds, you get the 90-Day Done Right Promise in writing: if something’s not right, we come back and make it right, no paperwork fight.
What Mr-Glass Roof Replacement & Installation Costs in Fort Lauderdale
Mr-Glass roof work isn’t flat-rate, but here are honest ranges based on what we’ve quoted in Fort Lauderdale over the last few years:
- Reseal a leaking Mr-Glass roof panel or skylight: $350-$750, depending on panel size and whether the frame needs cleaning or repair.
- Replace a single Mr-Glass roof panel with comparable tempered glass: $900-$2,200 installed.
- Full Mr-Glass overhead unit replacement with new frame and hardware: $2,500-$6,500, driven by glass size, curb condition, and whether it’s a flat or sloped assembly.
- Hardware and latch replacement only: $150-$450 including labor, when parts are available.
What moves the price: glass thickness and lamination, whether the curb is rotted or out of level, second-story access, and whether you’re keeping the existing frame. We never add a charge after the quote is signed. Call (754) 310-3589 for a free estimate on your specific Mr-Glass roof unit.
Why Fort Lauderdale Homeowners Call TruePane Windows & Doors for Mr-Glass Work
We’ve been in Fort Lauderdale long enough to know what Atlantic salt does to roof glazing, and we’ve repaired enough Mr-Glass units to know which corners fail and which ones hold. The Keystone Standard means both manufacturer warranty layers get registered in writing before our truck leaves your driveway, and the 90-Day Done Right Promise means we stand behind the work without arguing. If your Mr-Glass unit is beyond saving, we’ll show you the numbers on PGT, CGI, or ES Windows roof-rated options, because sometimes the best fix for an orphaned brand is a panel that’s actually in stock. Dale Kessler has been setting glass true since he was a kid watching his father cut panes in a Columbus garage, and that habit stuck: if the pane is not true, the job is not done.
FAQs
We work on Mr-Glass roof units as an independent Mr-Glass service provider, not as a factory-authorized agent, so we handle the labor and material regardless of whether the manufacturer warranty still applies. If a warranty is live, we’ll register the work and document everything so you can file the claim cleanly. Call (754) 310-3589 and tell us what you’re seeing; we’ll tell you honestly whether the warranty is worth pursuing.
Some Mr-Glass panels and hardware are still available from distributors, and some are effectively gone. We’ll check before we quote, and if OEM isn’t available we’ll show you an equivalent aftermarket panel side by side with the numbers, so you’re never buying a mystery substitution.
Most replacements are done one to three days after the panel or frame arrives, and we can usually get commonly sized units within a week. If your roof is actively leaking, call (754) 310-3589 and we’ll get a tarp over the opening the same day if needed while the replacement comes in.
If the glass is intact and the frame is sound, a reseal or hardware swap usually makes sense and costs a fraction of replacement. If you’ve got multiple stress cracks, corroded framing, or a curb that’s losing its level, replacement is the honest answer, and we’ll tell you that before we quote.
No. We quote a fixed price after measuring the opening and inspecting the curb, and we don’t add line items mid-job. The number on the paper is the number on the bill. Call (754) 310-3589 for your free estimate.
Written by Dale Kessler, Owner, TruePane Windows & Doors at TruePane Windows & Doors, serving Fort Lauderdale and nearby areas.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.